First.Package, Transportation, Storage
1. To keep eligible products from bumping with each other, we adopt such methods as following: put some pearl cotton between two layers of spraying sections and package each with a layer of composite paper exteriorly; put the transparent film between two layers of electrophoresis sections and package each with a layer of composite paper exteriorly; separate each pigment oxide sections with a transparent film,and each sections should be with a security label (orspraying code); stick an acceptance certificate at one end of every bundle, which contains such information as manufacturer, logo, product name, type, etc..
2.When the packing box is needed, it should be hard enough to keep products from crashing each other and any damage.
3.The conveyance should be equipped with some flashing devices to keep it dry, clean, and free from pollution.
4.Put the products gently, never throw, toss and bump the products.
5.Put the products in a well-ventilated and dry place. Keep them away from acid, alkali, salt, and other similar products. Protect them from rainwater.
6. Keep the products from the earth. Block the bottom up minimum 10cm.
7. Put the products on an even filling with an angle of 70¡æ.
Second, construction matters needing attention:
1, opens when must glue the protective film, when the manufacture wants the handle with care, avoids scratching the flower, the pulling injury.
2, installs when avoids the belt alkalinity, pollutant contact molding surface and so on acidic cement, mortar, solvent but creates the corrosion.
3, the installment forbids the worker to climb up, to step on.
Third, use maintenance:
Construction molding in long-term use, as a result of dust and dirt deposition absorption moisture, specially when in the air includes the sulfide suffers the corrosion, therefore must the clean principle surface by lengthen the service life on time, the clean principle cycle is generally half year, when the cleaning up both must clean up the superficial dirt and or the damage surface oxide film, the electricity swims the compound membrane, spurts spreads the powder. The clean principle dirt uses generally includes the suitable lubricant or the neutral soap lye hot water cleans, also may use the textile fiber to brush except the dust which adheres to stick cohere, does not permit the use sandpaper, the steel wire brush either other rubbers does not permit with the acid or the alkali carries on the clean principle, must use the clean laundering after clean processing; The struggle, specially has the crevasse, the dirt place, but also must use the soft cloth to stain the ethyl alcohol to scour, finally uses the high quality wax to make polishing processing to the anode oxide film.
